Home > Quality & Environment

Pioch, an ISO 9001:2008 certified company

Quality management for the design and manufacture of components for electrical equipment

The ISO 9001:2008 standard specifies generic requirements for the management systems implemented at Pioch for the design and manufacture of components for electrical equipment (transformers, racks, motors, turbine or solar engine, etc.) produced on the Carros site (Alpes-maritimes, France).

It applies to the processes Pioch uses to produce its products, in other words, how it works and the way it responds to its customers' requirements.

ISO 9001:2008 applies to processes affecting the quality of the products or services of a company. ISO 9001:2008 does not contain requirements relating to specific products or services.

Source : http://www.iso.ch



	PIOCH, electrical transformer equipment manufacturer - 06 515 Carros France - Tél. : +33(0) 493 290 725 - Fax : +33(0) 493 292 211 - www.pioch.com - piochsas@pioch.fr - Site map Busbar Bushing, sortie moyenne tension, busbar bushing for indoor use, busbar bushing for outdoor use, bind busbar bushing, monobloc bushing, monobloc busbar bushing, special bushing - Protective cover for busbar bushing, protective sheath for busbar bushing, protective cover for porcelain bushing, protective sheath for porcelain busbar bushing - Rod bushing, round rob bushing, bushing fixing, terminal board, terminal box, lead boards, lead bords, wire grommet - Linear tap changer, rotative tap changer - Cast coil support, busbar supports, support of bar set, winding spacers - End spacer, duct strips, laddenducting, clack band - Special parts for electrical transformers : washer, flange pipe, pipe plate, insulating plate, insulating fixing - Quick prototyping : small production for high voltage materials, special parts for windmills, waterproofing for fiber optic outlets, terminal strips, insulating parts for solar energy, multipin connector, press-fit connector, direct numerical production, complex structured parts.